HI Mike,
Check the length of the screws for the corner bracket. I used new ones on my
BN1 windshield and cracked one corner.
Had to get a new piece of glass and used my old, original screws and it worked
fine.
Some people use silicone spray, some use water with a bit of dishwashing soap
for lubrication.
Rob
( anyone need a brand new XXX windshield with just a small chip in the corner )
?
> On May 25, 2017, at 6:29 PM, Michael MacLean <rrengineer.mike at att.net>
> wrote:
>
> Thanks Bob. I have the glazing rubber from Moss, but I seem to remember a
> problem a while ago about the rubber being too thick I hope not. The only
> other question I might have is, did you use a rubber mallet? Do you need some
> kind of lubrication? It looks to be a tight fit. Once it is on, I won't be
> able to move laterally if it's too far to the right or left. Sounds like you
> have to get ot right the first time.
> Mike
>
|