The minimum rim width for 205/70 section tires is about 5,5", so the
6,5'' rims should be fine. If you have any slight clearance issues,
these can usually be addressed to by having the spokes adjusted to get a
suitable offset (within limits).
Kees Oudesluijs
Op 26-9-2015 om 21:27 schreef Chris Scholz:
> I am looking into buying new 72 spoke Dayton wire wheels for my '59 100-6 and
> will also get new tires at the same time.
> Thinking about running staggered sizes --- I am making much more horsepower
> than stock and was looking at using Vredestein 205/70HR15 for the rear which
> are 26.3" in diameter and section width is 8.2".
> Front tires could remain stock (165/15) which are 25.43" by Firestone or
> Vredestein.
>
> Are 205 section tires too wide for Dayton rims? Coker says they are fine.
> Believe 72 spoke Daytons are 6.5" wide.
>
> Wondering how it will look with staggered sizes. Anybody else try this?
> Thanks.
>
> Sent from my iPhone
> Chris Scholz OD
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
> Suggested annual donation $12.75
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
>
> Healeys@autox.team.net
> http://autox.team.net/mailman/listinfo/healeys
>
> Unsubscribe/Manage:
> http://autox.team.net/mailman/options/healeys/coudesluijs@chello.nl
>
>
>
> -----
> Geen virus gevonden in dit bericht.
> Gecontroleerd door AVG - www.avg.com
> Versie: 2015.0.6140 / Virusdatabase: 4419/10703 - datum van uitgifte: 09/26/15
>
>
_______________________________________________
Archive: http://www.team.net/archive
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
|