Michael,
Hole saw that pilots on the pin? A series of (smaller) holes drilled in
the bushing, adjacent to the pin? I'm thinking that if you can remove
the outboard bushing, then you should be able to drive out the inboard
bushing.
Cheers,
Bob Haskell
AHCA 3000 Mk I registrar
http://www.ciahc.org/registry_3000mk1.php
On 06/25/2015 05:42 PM, Michael wrote:
> I left the seized shackle pins in both sides of this BN1 when it went
> off to TechnoStrip in the hope that they would come loose.
> They didn't so I've spent an inordinate amount of time trying to extract
> them without wreaking the mounts on the frame.
> Made a special puller, applied loss of heat, drilled right through each
> bush, grumbled a lot but they will not move despite being subjected to
> massive amount of force.
> Any ideas...damaging the mounts in the chassis makes for a very tedious
> repair.
> Michael S.
> BN1 #174
>
>
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
> Suggested annual donation $12.75
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
>
> Healeys@autox.team.net
> http://autox.team.net/mailman/listinfo/healeys
>
> Unsubscribe/Manage:
> http://autox.team.net/mailman/options/healeys/rchaskell@earthlink.net
>
_______________________________________________
Archive: http://www.team.net/archive
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
|