Try to turn the drive flange counter clockwise, slowly.
Magnus Karlsson
BorC%s Motor Corporation AB
www.concourshealeys.com
> 7 jul 2014 kl. 20:33 skrev Fred Wescoe <fredwescoe@gmail.com>:
>
> I am trying to reattached the overdrive unit to the transmission of my
> BJ7. The two sets of splines in the overdrive are aligned properly and I
> have used safety wire to wire down the pump plunger to it lowest position.
>
> The overdrive is on the transmission studs and the ends of the stubs are
> just at the rear face of the overdrive case, not enough to get a nut on but
> close. The housing of the overdrive is 3/16" away from the transmission
> housing.
>
> I have put grease on the end of the main-shaft, grease on the roller on top
> of the pump plunger and grease on the bottom of the eccentric ring that
> operates the pump plunger.
>
> I have tapped on the drive flange (not banged), tried to twist the
> overdrive, tried to shake it left/right/up/down and tried to rotate the
> drive flange. The transmission is in 4th so nothing moves. I have also
> tried all of these with the transmission in neutral. No luck with any of
> that.
>
> I have tried many, many times to seat the overdrive and it just will not go
> together. It is always just the 3/16' short of mating up.
>
> What am I doing wrong? What should I look for or do?
>
> Fred
> 63 BJ7
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
> Suggested annual donation $12.75
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
>
> Healeys@autox.team.net
> http://autox.team.net/mailman/listinfo/healeys
>
> Unsubscribe/Manage:
http://autox.team.net/mailman/options/healeys/magnuskarlsson@bornet.net
_______________________________________________
Archive: http://www.team.net/archive
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
|