| To: | richard mayor <mayorrichard@hotmail.com> |
|---|---|
| Subject: | Re: [Healeys] Steering column issue |
| From: | john spaur <jmsdarch@sbcglobal.net> |
| Date: | Mon, 30 Sep 2013 21:34:14 -0700 |
| Cc: | healeys@autox.team.net |
| Delivered-to: | mharc@autox.team.net |
| Delivered-to: | healeys@autox.team.net |
| References: | <BAY173-W4241C43201513818B5FC4BC0150@phx.gbl> <6.2.3.4.2.20130930192544.0511c9d8@pop.att.yahoo.com> |
Richard, Too much heat will cause the solder to fail and not adhere. MAPI gas is sufficient. It is possible some of the boxes were assembled with silver braze which has a higher melting point than solder or silver solder. The rocker shaft oil feed pipe is silver braze. John At 07:30 PM 9/30/2013 -0700, john spaur wrote: >At 01:31 AM 10/1/2013 +0000, richard mayor wrote: >>I applied massive heat to the box to melt the solder with my oxy torch _______________________________________________ Archive: http://www.team.net/archive Healeys@autox.team.net http://autox.team.net/mailman/listinfo/healeys |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: [Healeys] Steering column issue, john spaur |
|---|---|
| Next by Date: | Re: [Healeys] High speed miss - CARBS? - followup, john spaur |
| Previous by Thread: | Re: [Healeys] Steering column issue, john spaur |
| Next by Thread: | Re: [Healeys] High speed miss - CARBS? - followup, john spaur |
| Indexes: | [Date] [Thread] [Top] [All Lists] |