2. Use silver solder because if you powder coat the box it has a
higher melting point than regular solder. It would ideal to have a
melting point greater than 450F. You can use a propane torch with
MAPI gas. Clean well, tin the tube, use plenty of flux, assemble and
heat until the solder is drawn into the fitting.
1. You might need a mandrel and press to put the groove into place.
You might be able to solder a washer in the tube to act as a seat or
use cooper wire solder in place.
John
At 01:31 AM 10/1/2013 +0000, richard mayor wrote:
>I am rebuilding a steering box/column. It had been in an ugly encounter
>sometime in it's life and the bottom of the tube, where it goes into the box,
>was buckled. I applied massive heat to the box to melt the solder with my oxy
>torch in order to remove the tube. I have some new tubing, bought from a local
>source, that has the same OD and wall thickness.
>
>Here are my questions: (1) I need to swage a groove around the upper end of
>the tubing to retain the 2" felt bushing at the top of the column. Any ideas
>on how to do this? Or, is there another way of keeping the felt bushing in
>place...at the top of the column?
>(2) Any tips on sweating the new column into the box. I have experience
>doing this with 1/2" and 3/4 " copper fittings but not with sweating a steel
>tube into a big cast iron steering box. Any tips?
>_______________________________________________
>Support Team.Net http://www.team.net/donate.html
>Suggested annual donation $12.75
>Archive: http://www.team.net/archive
>Forums: http://www.team.net/forums
>
>Healeys@autox.team.net
>http://autox.team.net/mailman/listinfo/healeys
>
>Unsubscribe/Manage:
>http://autox.team.net/mailman/options/healeys/jmsdarch@sbcglobal.net
_______________________________________________
Archive: http://www.team.net/archive
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
|