Well, I remember when this subject first came up on the list. It was just
after I had installed a new flex hose in the oil line. Afterward, the needle
was rock steady, but some said the line had to be bled. I cracked the nut,
started the engine and let it run until oil came steadily out of the line (into
a cup), tightened the nut, and then watched my needle vibrating so badly I was
afraid it would break off. Then, I disconnected the line and waited for a
minute before reconnecting it. The needle was steady again. To me, that says
that air is needed in the line to damp the needle.
It's my story, and I'm sticking to it.
I believe what happened to me in the desert was that the nut backed off and
allowed the oil pressure to bleed the air itself as I drove. BTW, oil did not
spurt out, or even drip, and I didn't see any oil until I looked under the dash
and saw the single drop on the nut. That tells me that Kees is right -- there
isn't much oil in the line (unless it's bled).
So we need a few more people to do the experiment and report back to the list.
It can't be correct both ways.
Steve Byers
HBJ8L/36666
BJ8 Registry
Havelock, NC USA
---- Roland Wilhelmy <rwil@sbcglobal.net> wrote:
> All I can say is that I followed Chris' recipe (minus the ex-wife's
> gift shirt) and it cured the needle vibration on our BJ7.
>
> -Roland
_______________________________________________
Archive: http://www.team.net/archive
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
|