Here is what a spring guy says....
"SO to answer the question, is it OK to powder coat springs? Well that
depends. In the amount of heat applied during the curing process. Too much
heat is harmful to springs. Once springs begin to get hotter than 350 degrees
Fahrenheit they begin to anneal, that is the steel starts to get soft, the
temper is lost and the spring will not support any weight.
In order to safely powder coat springs the temperature MUST remain below 350
degrees!!!!"
http://www.eatonsprings.com/powdercoating.htm
Sent from my iPhone
On 14/05/2013, at 5:23 PM, Charlie Frazer <cfrazer@jcomm.uoregon.edu> wrote:
> Kees,
> I respect your expertise.
> Could you tell me the specific evidence on which your caution about
> powder-coating is based?
> What specific effects are there on springs and roll-bars heated at 400
> degrees?
> Thanks,
> Charlie
>
> On May 13, 2013, at 10:38 PM, Oudesluys wrote:
>
> These relatively low temperatures of 400 do effect some some types of
spring
> steel of springs, anti-roll bars etc. so beware. There are little effects
on
> other parts.
> Kees Oudesluijs
> NL
>
>
> Op 14-5-2013 6:11, Charlie Frazer schreef:
>> Thanks to a number of you who expressed your personal opinions on whether
> to
>> paint or powder coat suspension springs, as well as discussing various
>> techniques for media blasting.
>>
>> My question is this: Does the heat involved in powder coating really
> result
>> in taking the temper out of springs as suggested in some recent posts?
>> I'm not a metallurgist, but it appears to me that the temps in powder
> coating
>> are around 400 degrees, while springs are tempered at 900-950 degrees.
So,
>> does the relatively low temperature in the powder coating oven really
> affect
>> springs? If so, how about A-arms and sway bars?
>>
>> Thanks for your comments.
>> ___
_______________________________________________
Archive: http://www.team.net/archive
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
|