Unfortunately I didn't take notes when I last did this conversion but I
believe that the 0.70 will do the job although I can not guarantee this 100
percent.
Magnus Karlsson
www.concourshealeys.com
1 nov 2012 kl. 02:21 skrev HealeyRick <healeyrick@yahoo.com>:
>
>
> Girling lists bores of 0.62 inch (the one I have); 0.70 inch and 0.75 inch
before getting to the 7/8 inch on the BJ8. I suppose I could give the .70
inch a try
>
> Rick
>
> "Madman in a death machine"
> Follow My Nasty Boy Build: http://tinyurl.com/yj52fwo
> From: Magnus Karlsson <magnuskarlsson@bornet.net>
> To: HealeyRick <healeyrick@yahoo.com>
> Cc: Healey Lista <healeys@autox.team.net>
> Sent: Wednesday, October 31, 2012 7:03 PM
> Subject: Re: [Healeys] Disc Brake Upgrade
>
> You can not use the 5/8" as the pedal will bottom out. There are one or two
sizes between the 5/8" and 7/8". Unfortunately I do not remember which one to
use but as said before I believe the next one up is ok. You do not have to go
as high as the 7/8" though, as it will, like someone said, result in a very
hard pedal.
>
> Magnus Karlsson
> www.concourshealeys.com
>
> 31 okt 2012 kl. 01:57 skrev HealeyRick <healeyrick@yahoo.com>:
>
>> I have no servo and am running the 5/8" BJ7 m/c (same as the BT7) The BJ8
w/servo is 7/8"
>> What's your opinion, stay with the 5/8 or go to the 7/8?
>>
>> Thanks
>>
>> Rick
>>
>> "
_______________________________________________
Archive: http://www.team.net/archive
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
|