Yep, I'll get my firendly mechanic to make one for me. I called SC and they
don't carry the water tap blanking plate in stock.
Derek
On Tue, Oct 30, 2012 at 6:06 PM, Tracy Drummond <bighealey@charter.net>wrote:
> Easy enough to make one from a flat of steel. Cut file and drill then
> make a gasket and presto.
>
> Sent from my iPhone
>
> On Oct 30, 2012, at 9:11 AM, Derek Job <derek.c.job@gmail.com> wrote:
>
> > Hi all,
> >
> > I'm removing the heater from my car as I figure it's hot enough already
> > and I want to remove all unecessary bits..
> >
> > I will be removing the heater tap, a side benefit being easier access to
> > number 6 plug. I've looked in various suppliers parts catalogues but
> can't
> > find a blanking plate to replace the tap.
> >
> > SC parts have a blanking plate for a pre 48862 BN4 water drain tap
> > replacement. From the diagram it looks very similar to the heater tap
> > arrangement. Anyone know if it would fit or where to get a blaking plate?
> >
> > Deek
> > _______________________________________________
> > Support Team.Net http://www.team.net/donate.html
> > Suggested annual donation $12.75
> > Archive: http://www.team.net/archive
> > Forums: http://www.team.net/forums
> >
> > Healeys@autox.team.net
> > http://autox.team.net/mailman/listinfo/healeys
> >
> > Unsubscribe/Manage:
> http://autox.team.net/mailman/options/healeys/bighealey@charter.net
_______________________________________________
Archive: http://www.team.net/archive
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
|