Easy enough to make one from a flat of steel. Cut file and drill then make a
gasket and presto.
Sent from my iPhone
On Oct 30, 2012, at 9:11 AM, Derek Job <derek.c.job@gmail.com> wrote:
> Hi all,
>
> I'm removing the heater from my car as I figure it's hot enough already
> and I want to remove all unecessary bits..
>
> I will be removing the heater tap, a side benefit being easier access to
> number 6 plug. I've looked in various suppliers parts catalogues but can't
> find a blanking plate to replace the tap.
>
> SC parts have a blanking plate for a pre 48862 BN4 water drain tap
> replacement. From the diagram it looks very similar to the heater tap
> arrangement. Anyone know if it would fit or where to get a blaking plate?
>
> Deek
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
> Suggested annual donation $12.75
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
>
> Healeys@autox.team.net
> http://autox.team.net/mailman/listinfo/healeys
>
> Unsubscribe/Manage:
http://autox.team.net/mailman/options/healeys/bighealey@charter.net
_______________________________________________
Archive: http://www.team.net/archive
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
|