These are cheap and cheerful units. I have not heard of failures yet,
but the loose fit seems to occur sometimes. Just apply a little sealant
and rotate the ring until it hits the cam properly and secure it. Let
the sealant cure fully. This will centre the ring and keep it fixed on
the cam without play. It is more or less the same system as from
Petronix and Luminition.
Kees Oudesluijs
Op 26-4-2012 10:44, Larry Varley schreef:
> Hi Guys, has anyone had experience with the Accu Spark distributor
> conversion for pointless operation on a BT7? I bought a kit out of
> curiosity, which was quite cheep and found that the firing ring that
> fits over the distributor cam, is quite a loose fit and can rotate a
> little on the cam, so I can't see how it could maintain regular
> timing. Has anyone successfully used this kit? The concept looked good
> as there are basically no modifications or extra wiring, and the
> sender unit fits well on the points plate.
> Cheers
> Larry
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
> Suggested annual donation $12.75
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
>
> Healeys at autox.team.net
> http://autox.team.net/mailman/listinfo/healeys
>
> Unsubscribe/Manage:
> http://autox.team.net/mailman/options/healeys/coudesluijs at chello.nl
>
>
>
> -----
> Geen virus gevonden in dit bericht.
> Gecontroleerd door AVG - www.avg.com
> Versie: 2012.0.1913 / Virusdatabase: 2411/4959 - datum van uitgifte:
> 04/25/12
>
>
--
Kees Oudesluijs
Dorpsstraat 183
2995XG Heerjansdam
T: 078-677 1233
E: coudesluijs at chello.nl
Technische commissie Jensen Healey en GT
Het Jensen Genootschap Holland
www.jensenholland.nl
|