Hi Gordy,
I don't think the problem is too serious. The hex nut that holds the
bulb into the radiator just clamps a flange between the threaded boss on
the radiator and the nut itself. If the leak is around the "spring"
covering the capillary tube just tightening the nut slightly may solve the
problem.
In the worst case you may need to remove the nut and the "bulb" to clean up
the mating surfaces.
Be very careful to ensure that the "spring" does not turn with the nut as
you loosen it. The little wire inside the spring is actually a very thin
tube which contains ether and if strained the tube will easily break....
proceed with caution.
--
Michael Salter
Check My Blog
http://www.netbug.net/blogmichael/
On Tue, Apr 3, 2012 at 5:42 PM, <ggilliam at usol.com> wrote:
> A couple days ago I noticed a damp area under the car, a Longbridge BN4,
> and the coolant level down in the radiator. Since it was reasonably warm
> today I investigated the condition and it looks like the thermal system
> tube for the water temp indicator is the source of the leak. In this car
> the bulb is installed in the bottom of the radiator top tank, and the leak
> appears to be where the small coil wound tube enters the larger bulb.
> Has anyone experienced this condition, and is there a fix short of having
> to remove the gauge and thermal system and get it rebuilt? I don't think
> the leak rate is significant, but things always seem to fail at the most
> inconvenient times or in the worst places. I was thinking of trying to put
> some epoxy putty around the tube, or RTV....I don't think duct tape will
> work here....
>
> Regards,
> Gordy
> Fenton, MI
> _____________
|