Heat with map gas let cool, then try turning nut.
On Feb 21, 2012 7:04 AM, <ahy3000@comcast.net> wrote:
> All,
>
> I've got a pair of HS6s mostly disassembled but cannot budge the jet
> locking nut on either carb. I am presently soaking the jet bearing/jet
> locking nut in PB Blaster to see (hope) that it helps. I'm afraid to put
> too much torque on the nut until I get hold of a whitworth (I believe 3/8
> W) socket. Even then, I'll have to devise some sort of jig to hold the carb
> since my bench vise is 1/2" too small.
>
> Anyone encounter this before? Suggestions?
>
> On another note - I've gotten a lot out of this list and finally got
> guilted into sending some money to Mark via paypal.
>
>
>
> Burt Weiner
> '63 BJ7
> HBJ7L/23582
> ahy3000@comcast.net
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
> Suggested annual donation $12.75
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
>
> Healeys@autox.team.net
> http://autox.team.net/mailman/listinfo/healeys
>
> Unsubscribe/Manage:
> http://autox.team.net/mailman/options/healeys/eyera3000@gmail.com
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Suggested annual donation $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
|