All,
I've got a pair of HS6s mostly disassembled but cannot budge the jet locking
nut on either carb. I am presently soaking the jet bearing/jet locking nut in
PB Blaster to see (hope) that it helps. I'm afraid to put too much torque on
the nut until I get hold of a whitworth (I believe 3/8 W) socket. Even then,
I'll have to devise some sort of jig to hold the carb since my bench vise is
1/2" too small.
Anyone encounter this before? Suggestions?
On another note - I've gotten a lot out of this list and finally got guilted
into sending some money to Mark via paypal.
Burt Weiner
'63 BJ7
HBJ7L/23582
ahy3000@comcast.net
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Suggested annual donation $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
|