Then apply a good gas tank sealant. I've had the Bill Hirsch product in the
BJ8 for over 20 years with nary a problem
(on what passes for gasoline in California, to boot).
Bob
On 11/27/2011 9:56 AM, Jackson Krall wrote:
> At Home Depot you should find "Phosphoric Prep and Etch" by Klean-Strip in
> the paint dept. and "Metal Prep Dip Rust Remover" by Zep in the cleaner and
> chemical isle over near the chainsaws.
> Best
> JK
>
> On Sun, Nov 27, 2011 12:34 PM EST Ron Ray wrote:
>
>> Folks,
>>
>> A friend has his relative new Bugeye fuel tank repaired and now has a light
>> coat of "flash" rust on the inside.
>> Is the Moss fuel tank cleaner (part number 220-620) the most practical way
>> to remove this light rust coating, or is there a simpler less expensive
>> process?
>>
>> Thanks,
>> Ron
>> _______________________________________________
>>
>>
--
*******************************************************************
Bob Spidell San Jose, CA bspidell at comcast.net
*******************************************************************
|