Why not have them measured for stretch and taper at your machinist? Bring the
conn rods too in case they have to knurl the bolt to get a consistent clamp
and big end diameter.
Cheers,
Chris
BJ8...being sanded
Sent from my iPhone
On Nov 20, 2011, at 1:09 PM, john spaur <jmsdarch at sbcglobal.net> wrote:
> I am working on the engine and have realized that the connecting rod bolts
might be the original ones. I have read that they can stretch and should be
replaced. However, it does not appear that they are available for a 1962
engine. I noticed that the Moss catalog lists ones for a BJ7 and BJ8 with the
difference between those and the BT7 engine being the length of the locking
pin.
>
> Should I consider replacing the bolts (very expensive)?
>
> Thank you,
> John
> _______________________________________________
> Healeys at autox.team.net
> Donate: http://www.team.net/donate.html
> Suggested annual donation $12.75
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe/Manage:
http://autox.team.net/mailman/options/healeys/csooch1 at aol.com
|