I did not find a spec in the workshop manual; will a machine shop
know the specs?
Thank you,
John
BT7 waiting for the engine!
At 02:05 PM 11/20/2011 -0600, Chris Masucci wrote:
>Why not have them measured for stretch and taper at your
>machinist? Bring the conn rods too in case they have to knurl the
>bolt to get a consistent clamp and big end diameter.
>
>Cheers,
>Chris
>BJ8...being sanded
>
>Sent from my iPhone
>
>On Nov 20, 2011, at 1:09 PM, john spaur <jmsdarch@sbcglobal.net> wrote:
_______________________________________________
Healeys@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|