Thanks!
2011/4/23 Austin Healey <pajtamuvek at gmail.com>
> Can anybody tell me the aprox thickness of this pad? Only on one side or
> each sides have one?
>
> Gergo
>
> 2011/4/23 <healeymanjim at hansencc.net>
>
> andrea, when i rebuilt the trans in the bn6, i did not know about that
>> buffer and did not replace it. about a month later it cracked in half (it
>> was some kind of plastic) allowing the high gear rod to move forward enough
>> to allow balls and springs to fly all over inside. needless to say, had to
>> pull trans and try to figure out problem. i replaced the plastic piece with
>> leather or rubber (cannot remember exactly) and it has worked fine ever
>> since. make sure to measure thickness and replace with a material that will
>> not compress too much allowing shift rod to move too far forward. hjim
>> _______________________________________________
>> Healeys at autox.team.net
>> Donate: http://www.team.net/donate.html
>> Suggested annual donation $12.75
>> Archive: http://www.team.net/archive
>> Forums: http://www.team.net/forums
>> Unsubscribe/Manage <http://www.team.net/forumsUnsubscribe/Manage>:
>> http://autox.team.net/mailman/options/healeys/pajtamuvek at gmail.com
|