Can anybody tell me the aprox thickness of this pad? Only on one side or
each sides have one?
Gergo
2011/4/23 <healeymanjim@hansencc.net>
> andrea, when i rebuilt the trans in the bn6, i did not know about that
> buffer and did not replace it. about a month later it cracked in half (it
> was some kind of plastic) allowing the high gear rod to move forward enough
> to allow balls and springs to fly all over inside. needless to say, had to
> pull trans and try to figure out problem. i replaced the plastic piece with
> leather or rubber (cannot remember exactly) and it has worked fine ever
> since. make sure to measure thickness and replace with a material that will
> not compress too much allowing shift rod to move too far forward. hjim
> _______________________________________________
> Healeys@autox.team.net
> Donate: http://www.team.net/donate.html
> Suggested annual donation $12.75
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe/Manage:
> http://autox.team.net/mailman/options/healeys/pajtamuvek@gmail.com
_______________________________________________
Healeys@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|