John,
May not be relevant, but the earlier 100 BN2 diagram has the three
wires you
mention plus the fourth is the supply to the fuel pump. Don't know
if this
helps.....
Mike Brooks
'56 BN2
Scotland
Date: Sat, 09 Apr 2011
21:13:10 -0700
From: john spaur <jmsdarch at sbcglobal.net>
Subject: [Healeys]
Fuse block terminal A3
To: healeys at autox.team.net
Message-ID:
<6.2.3.4.2.20110409210804.02064938 at pop.att.yahoo.com>
text/plain; charset="us-ascii"; format=flowed
1962 MKII BT7
My wiring
diagram shows three white wires attached to fuse block
terminal A3. My wiring
harness has four white wires.
One goes to the overdrive relay, one goes to
the S.W. connector on
the ignition coil and one goes to the overdrive switch.
The forth wire is in the wiring harness and follows the same route as
the
wire that goes to the overdrive switch.
My original harness only had three
white wires.
What is the purpose of the forth wire?
Thank you,
John Spaur
Reply to: mike.brooks at alumni.warwick.ac.uk
|