Scott,
I used a product called Q-Pad. It does not have the aluminum layer
and seems stiffer than dynamat so it is a little harder to install.
It was recommended to me by a jag restorer. You will need to measure
the areas you intend to place it to get an estimate of the square
footage. I installed it on the floor and on the front footwell. Some
people also install it in the doors and on each side of the front
footwell. I also placed it under the tar paper on the interior of the
firewall. I have not driven my car yet so I do not know how well it will work.
http://www.evercoat.com/productDetail.aspx?pID=50
John
'62 BT7
At 11:01 AM 3/27/2011 -0500, scott willis wrote:
>Hi folks,
>I am now ready to install a heat barrier.... how much I will need to
>buy, and where to get it?
>Scott Willis
|