John, sorry, but I have to disagree. Aluminium (sorry - aluminum) is the
weakest of the two mating materials and therefore the main problem with this
joint will be the aluminum which will suffer from electrolytic(galvanic)
corrosion. A rust film will form on the steel, but it's the aluminum that
will disappear much faster than the steel. Therefore corrosion is the
problem, not rust.
Jack Aeckerlin, The Netherlands
1964 BJ8 29432
2010/10/16 john spaur <jmsdarch@sbcglobal.net>
> Rust is the problem with this joint, not corrosion! Paint the mating
> surfaces well. I also ran caulk on the seam, feathered it out and finished
> it with paint. It's not perfectly finished and I doubt it's Concours either.
> John
>
> At 08:59 AM 10/15/2010 +0200, Jaap Aeckerlin wrote:
>
>> Bob, you have to realise that electrolytic corrosion only takes place when
>> the relative humidity at the joint is over 50%. Any permanent elastic
>> mass....
>> Jack Aeckerlin, The Netherlands
>> 1964 BJ8 29432
>>
> _______________________________________________
> Healeys@autox.team.net
> Donate: http://www.team.net/donate.html
> Suggested annual donation $12.75
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe/Manage:
> http://autox.team.net/mailman/options/healeys/j.aeckerlin@gmail.com
_______________________________________________
Healeys@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|