..and replace the small o-ring oil seals at each end while you're there..
dave
frogeye@porterscustom.com
Porter Customs 2909 Arno NE
Albuquerque, NM USA 87107
505-352-1378
1954 BN2 1959 AN5
Porter Custom Bicycles
cars:
www.britishcarforum.com/portercustoms.html
gallery:
http://picasaweb.google.com/porterscustombicycles/PorterCustomBicyclesStuff
blog: http://porterbikes.com/
-----Original Message-----
From: healeys-bounces@autox.team.net [mailto:healeys-bounces@autox.team.net]
On Behalf Of Peter Schauss
Sent: Tuesday, September 21, 2010 8:00 PM
To: healeys@autox.team.net
Subject: Re: [Healeys] Intermittent OD:the answer
There is also an end float specification for the shaft which runs through
the overdrive. If you don't allow enough end float, the solenoid will not
be strong enough to overcome the friction.
Peter Schauss
1963 BJ7
1980 MGB
> -----Original Message-----
_______________________________________________
Healeys@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|