Hi List,
A friend of mine is rebuiding the engine of his morris minor. It is the same
engine as used in the A-H sprite MK 2 and the MG midget MK 1.
The engine is 1098 cc referred to as type 10CG.
Following info is asked for:
- Which is the diameter of the standard crankshaft as well as the tolerances.
- If he wants to grind off the crankshaft, how many times would this be
possible, which are then the resp. diameters and corresponding tolerances?
- Which size of bearing should be used in this cases.
Would be nice also to recieve these figures in the metrc system.
Hope the question is clear?
thanks and regards,
Ge Aagten
The Netherlands
A-H BJ8
_______________________________________________
Healeys@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|