Thanks Dallas. I was thinking I would need a press to clip the edge.
I have tin snips - will that get it? I assume these are 1/16"
thickness or so.
Olin
On Aug 7, 2010, at 6:41 PM, Dallas Congleton wrote:
> Olin, if you don't find them, make your own. Get some 5/16 fender
> washers ( available in the bins at Lowes), and trim one side with
> metal snips.
> Dallas Congleton
> Little Washington NC
>
>
> ----- Original Message ----- From: "Olin Brimberry" <healey@hunterbane.com
> >
> To: <healeys@autox.team.net>
> Sent: Saturday, August 07, 2010 6:01 PM
> Subject: [Healeys] "D" shaped washers for the fuel tank strap
>
>
>> Does anyone have an extra set of 2 of these washers. I took my
>> tank out and when putting the straps back on, I misplaced the
>> washers. These are the 2 that are D shaped so that it will fit
>> against the flange to the rear shoud.
>>
>> Thanks,
>>
>> Olin Brimberry
>> Raleigh, NC
>> _______________________________________________
>> Healeys@autox.team.net
>> Donate: http://www.team.net/donate.html
>> Suggested annual donation $12.75
>> Archive: http://www.team.net/archive
>> Forums: http://www.team.net/forums
>> Unsubscribe/Manage:
>http://autox.team.net/mailman/options/healeys/dcongleton@embarqmail.com
_______________________________________________
Healeys@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|