There's a spring-loaded rubber seal on the end of the pistons on brake
and clutch M/Cs. This allows fluid from the reservoir to enter the
system when the piston is out, but needs to seal off the pipe to the
reservoir when you press the pedal. If this fails you might get the
symptoms you describe (I've had it happen on a brake M/C, but not a
clutch M/C). Have someone work the pedal while you watch the fluid
level--if it rises when your helper presses the clutch pedal this is
likely your problem. What puzzles me, however, is where the 'extra'
fluid is coming from--possibly, the fluid was sucked from the circuit to
the slave cylinder.
If the M/C is otherwise in good shape--i.e. no pitting--you should be
able to get by with a rebuild kit. If not, and your M/C is aluminum, a
resleeving or new cylinder is in order.
bs
John Soderling wrote:
> On the way home to Walnut Creek, Ca from a great week at Healey Rendezvous
> 2010 in Eugene, Oregon, I lost my clutch ( actually it was Erika the Red, my
> 100-six that lost her clutch) about 150 miles from home. When I checked the
> dual outlet clutch/brake tank, the clutch system had pumped additional fluid
> back into the tank to where it actually overflowed a little.
>
> So is it more likely a failed master cylinder or slave cylinder? I'm thinking
> the master, but not sure. Thanks.
>
> Vrooom vrooom,
> John
> _______________________________________________
>
>
>
--
*******************************************************************
Bob Spidell San Jose, CA bspidell@comcast.net
*******************************************************************
_______________________________________________
Healeys@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|