Peter,
There are two alignment arrows. On the propshaft I looked at, the arrow
on the front piece was about mid-span in-line with the grease nipple.
On the rear tube, the arrow is just after the weld.
I believe the yokes should be in the same plane.
Cheers,
Bob
Peter Schauss wrote:
> Are the yokes at the front and rear of the drive shaft supposed to be in
> line or 90 degrees apart? What happens if the two ends are not in the
> proper relationship to each other?
>
> Last year I sent my drive shaft out to have the universal joints replaced
> and to be balanced. When I got it back the front yoke was about 20 degrees
> off from the rear yoke. Needless to say, I had not bothered to see how it
> was set up before I sent it out.
>
> Thanks,
> Peter Schauss
> 1963 BJ7
> 1980 MGB
_______________________________________________
Healeys@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|