Robert,
That's a full 5/8" less than the measurement I got. That seems strange. You
sure your dipstick tube is full original length?
Rich
--------------------------------------------------
From: "robert westcott" <55healey@comcast.net>
Sent: Sunday, March 14, 2010 8:17 PM
To: "Rich C" <richchrysler@quickclic.net>
Cc: <healeys@autox.team.net>
Subject: Re: [Healeys] Fw: AW: 100 with DW aluminum sump-
> Thanks Rich,
>
> I just measured the depth of my new aluminum pan.
> The length from the bottom of the sump to the top of the
> dipstick tube was 13 1/8" or 33 cm.
>
> Rob
>
> On Mar 14, 2010, at 2:52 PM, Rich C wrote:
>
>> --------------------------------------------------
>> From: "Rich C" <richchrysler@quickclic.net>
>>
>> Thomas, et al,
>>
>> I just took two measurements on a stock Hundred engine and have found
>> the
>> following:
>>
>> - total depth of stock undamaged oil pan 5 3/16" or 13.3 CM
>> - length from bottom of oil sump to top of dipstick tube 13 3/4" or 35
>> CM
>>
>> Hope this helps,
>> Rich Chrysler
_______________________________________________
Healeys@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|