Am building race engine for Pocono (April 11th) and have run against snag.
Dennis Welch Motorsports is back ordered 4-6 wks on the flat top 88mm
pistons, which requires my sourcing a set of racing pistons elsewhere. if
anyone on the list has had a custom set fabricated by JE Pistons or a
similar piston maker, i would appreciate the specs and/or order # so i could
piggyback off the design specs? am sticking with the stock wrist pins
(floating in piston, clenched to con rod).
alternately, if anyone knows of a set for sale somewhere, would be very
interested.
also interested in speaking with anyone with experience
engine is otherwise in the works, and i am loathe to use my existing set of
0.20" over M-spec (shallow dish) pistons a stopgap measure, since it means
building a second short block for a single season's use.
also could use input from anyone with information as to locations and depths
for valve relief pockets.
thanks.
allen miller
bn2-m
_______________________________________________
Healeys@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|