If you're asking about the end link bushings, tighten the nuts until the
bushings are flattened to the diameter of the
flat washers (or a bit less).
Bob
Eric (Rick) Wilkins wrote:
> It's probably best to settle the car before torquing down the brackets.
> There's no "adjustment", you just need to tighten the brackets flat to
> the frame.
>
> Wilko
>
> On Feb 21, 2010, at 12:26 PM, philritten@aol.com wrote:
>
>> I've replaced all of the bushings on my sway bar and remounted it. I
>> have two
>> questions
>>
>> 1) Do I need to put the wheels back on the ground (or on ramps) before
>> doing
>> the final tightening? The car is currently on jack stands
>>
>> 2) How much should I tighten the bushings?
>>
>> Thanks all
>>
>> Phil
--
*******************************************************************
Bob Spidell San Jose, CA bspidell@comcast.net
*******************************************************************
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
http://www.team.net/archive
|