Thanks Bob,
So that means that all these repro kits must be including a "one size fits
all" under floor piece that seems to be shorter so it will also fit the BJ8.
Rich
----- Original Message -----
From: "Bob Yule" <autofarm@cyg.net>
To: "Rich C" <richchrysler@quickclic.net>
Sent: Wednesday, January 20, 2010 12:42 PM
Subject: Re: [Healeys] fire wall heat shields
> Rich, as far as part numbers go. The factory parts book gives the same
> part # for BN7, BT7and BJ7 and including tri-carb.
> Cheers.......Bob
>
> Subject: Re: [Healeys] fire wall heat shields
>
>
>> Somebody needs to come up with the pattern for the tricarb under floor
>> heat
>> shield panel. It's similar to that of the BJ8 but is about 5 1/2" longer
>> at
>> the back of the panel with different spacings. I suspect the one for the
>> BJ7
>> may be similar. The BJ8 one probably had to be shorter at the back edge
>> to
>> clear the pair of exhaust mounts that mount on studs through the floor
>> just
>> ahead of the rear left outrigger.
>>
>> Rich Chrysler
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
http://www.team.net/archive
|