Somebody needs to come up with the pattern for the tricarb under floor heat
shield panel. It's similar to that of the BJ8 but is about 5 1/2" longer at
the back of the panel with different spacings. I suspect the one for the BJ7
may be similar. The BJ8 one probably had to be shorter at the back edge to
clear the pair of exhaust mounts that mount on studs through the floor just
ahead of the rear left outrigger.
Rich Chrysler
----- Original Message -----
From: "J. Scott Morris" <jstmorris@yahoo.com>
To: <healeys@autox.team.net>; <nir6709@aol.com>
Sent: Tuesday, January 19, 2010 10:43 AM
Subject: Re: [Healeys] fire wall heat shields
> Hello Bob; Attached are heat shield patterns done by Greg Wilkinson off a
> BJ8
> about 7 or 8 years ago. A copy has been forwarded to John Sims to
> consider
> for his web site at www.healey6.com
> --Scott Morris; Simcoe, Ontario, Canada; '60 MkI BN7 & '62 MkII BT7
> J. Scott Morris - Keep Smiling, Murphy Lives
>
> --- On Mon, 1/18/10, nir6709@aol.com <nir6709@aol.com> wrote: << hi, is
> there
> anyone that have made the shields that go on the firewall,if so where can
> can
> I get patterns for this I was planning on using hardi backer from home
> depot
> any tips on what not to do,or what else I should use for material. thanks
> for
> everybody's input. Bob >>
> __________________________________________________________________
> Looking for
> the perfect gift? Give the gift of Flickr!
>
> http://www.flickr.com/gift/
>
> [demime 1.01d removed an attachment of type application/pdf which had a
> name of Dimensions]
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
>
> Healeys@autox.team.net
> http://autox.team.net/mailman/listinfo/healeys
>
> You are subscribed as richchrysler@quickclic.net
>
> http://www.team.net/archive
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
http://www.team.net/archive
|