Jim,
Saw the car at Mike's memorial service. Very nice. I have the Kumhos
from Tire Rack on the tri-carb. Like them.
Get the car on a lift or take the gearbox cover off and see if the
solenoid is moving when you flip the switch.
Any idea where the OD harness came from? British Wiring (Auto Sparks
reseller) had two harnesses. The 'standard' one had smaller gage wire
than the OEM harness. The 'special' had the right gage wire (28
strand). Probably best to replace melted.
Bob Haskell
jwhlyadv@aol.com wrote:
> I am getting ready to start work on Future Fifty Founder Ben Moores first
> Healey a fully restored BN6 that needs finishing details and a few repairs.
> I have been on this list for fifteen years, read over 10,000 posts about
> tires but I wasn't paying attention.......
>
> First off we need tires. Currently the car is running JC Penny tires that
> must be twenty years old. Any suggestions for a modest priced tire?
>
> Second - I need the number for the correct NAPA fuel pump.
>
> Third - I need to replace rear axle seals. Moss lists the o-ring as fitting
> BN4-BJ8. I thought the BN4-BN6 o-ring was different, is it?
>
> Fourth - when you engage the Overdrive solenoid the noisy electric fuel
> pump drops in volume indicating a large current draw. The OD solenoid wires
> are melted. Clubmembers all say he needs a new solenoid. Isn't this the
> adjustment that is not letting the plunger travel all the way up to hit the
> switch?
>
> Thanks!
>
> Jim Werner
> Louisville, KY
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
>
> Healeys@autox.team.net
> http://autox.team.net/mailman/listinfo/healeys
>
> You are subscribed as rchaskell@earthlink.net
>
> http://www.team.net/archive
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
http://www.team.net/archive
|