Thanks to all who replied directly to me -- turns out it wasn't a list post,
it was in Norman's book (should have thought to look there first).
Sarah Carr
BN1 in PA
----- Original Message -----
From: "Carr&Edwards" <scvc70@epix.net>
To: "Healey List" <healeys@autox.team.net>
Sent: Tuesday, November 17, 2009 3:41 PM
Subject: [Healeys] carb heat shield
> Does anyone on the list remember a post giving directions for making an
> improved (larger) heat shield for the BN1/BN2???
>
> I remember instructions to put the pattern on a copier and enlarge it
> until
> dimension A - B measured X --- but apparently I didn't save the email, and
> I've searched the archives using every combination of terms I can think
> of,
> and I haven't been able to find it.
>
> (And thanks again to all those who sent me photos off-list of the carb
> support
> brackets; they're truly better than words!)
>
>
> TIA,
> Sarah Carr
> BN1 in PA
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
>
> Healeys@autox.team.net
> http://autox.team.net/mailman/listinfo/healeys
>
> You are subscribed as scvc70@epix.net
>
> http://www.team.net/archive
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
http://www.team.net/archive
|