Does anyone on the list remember a post giving directions for making an
improved (larger) heat shield for the BN1/BN2???
I remember instructions to put the pattern on a copier and enlarge it until
dimension A - B measured X --- but apparently I didn't save the email, and
I've searched the archives using every combination of terms I can think of,
and I haven't been able to find it.
(And thanks again to all those who sent me photos off-list of the carb support
brackets; they're truly better than words!)
TIA,
Sarah Carr
BN1 in PA
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
http://www.team.net/archive
|