----- Original Message -----
From: "John Sims" <ahbn6@verizon.net>
To: <healeys@autox.team.net>
Sent: Tuesday, August 11, 2009 4:54 PM
Subject: [Healeys] Throttle? linkage
> My BN6 with HD6's idles just fine at around 800 rpm and the mixture is
> correct as far as I can determine. Problem is that when I accelerate the
> linkage sticks coming down at about 2,000 rpm and stays there. When in the
> cockpit, trying to raise the pedal with my foot does nothing -- it is
> already up as far as it will go.
>
> Under the bonnet, when I goose the linkage by moving the relay shaft to
> carbs, it comes right down where it should at 800 even running past 2,000
> rpm. If I hold this shaft open above 2,000 rpms, it will only come back
> down
> to 2,000 rpm and I have to nudge the shaft to bring it back to 800.
>
> What am I missing???
>
> John Sims, BN6
> Aberdeen, NJ
>
> http://www.healey6.com
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
>
> Healeys@autox.team.net
> http://autox.team.net/mailman/listinfo/healeys
>
> You are subscribed as grday@btinternet.com
>
> http://www.team.net/archive
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
http://www.team.net/archive
|