My BN6 with HD6's idles just fine at around 800 rpm and the mixture is
correct as far as I can determine. Problem is that when I accelerate the
linkage sticks coming down at about 2,000 rpm and stays there. When in the
cockpit, trying to raise the pedal with my foot does nothing -- it is
already up as far as it will go.
Under the bonnet, when I goose the linkage by moving the relay shaft to
carbs, it comes right down where it should at 800 even running past 2,000
rpm. If I hold this shaft open above 2,000 rpms, it will only come back down
to 2,000 rpm and I have to nudge the shaft to bring it back to 800.
What am I missing???
John Sims, BN6
Aberdeen, NJ
http://www.healey6.com
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
http://www.team.net/archive
|