I'd be more worried about the speedo repair in that case!
On 8/7/09, john spaur <jmsdarch@sbcglobal.net> wrote:
> Bob,
>
> I have been told that if the cable goes to far into the speedo it can
> cause the speedo bearing to freeze which results in a broken angle
> drive. I am not sure what the correct penetration should be though.
> Angle drives can be easily repaired.
>
> John
>
> At 03:57 PM 8/6/2009 -0400, Bob Johnson wrote:
>>It has been suggested that speedo wobble can be caused by the tip of
>>the cable going too far into the back of the speedo.
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
>
> Healeys@autox.team.net
> http://autox.team.net/mailman/listinfo/healeys
>
> You are subscribed as healey.nut@gmail.com
>
> http://www.team.net/archive
>
--
Alan
'52 A90
'53 BN1
'64 BJ8
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
http://www.team.net/archive
|