Bob,
I have been told that if the cable goes to far into the speedo it can
cause the speedo bearing to freeze which results in a broken angle
drive. I am not sure what the correct penetration should be though.
Angle drives can be easily repaired.
John
At 03:57 PM 8/6/2009 -0400, Bob Johnson wrote:
>It has been suggested that speedo wobble can be caused by the tip of
>the cable going too far into the back of the speedo.
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
http://www.team.net/archive
|