Martin et al,
As part of my BN7 resto I wanted to take some structural measures to eliminate
the shakes. Among other things I welded in 1.5 angle iron on the tops of both
main rails from the motor mounts back to the crucifix. Welds were about 2
inches spaced about 2 inches apart.
I also welded in the 3/4 angle iron inside the tranny box as I call it and
added more weld on the cockpit side of the tranny opening. Balancing the drums
was also done.
No hard data but the car has no shake or rattle - just roll!
Keith Pennell
---- Martin Jansen <jule_enterprisesah@yahoo.com> wrote:
> The most common cause of drive train vibration is the compression buckle- just
> forward of the front bulkhead in the main chassis rail.
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
http://www.team.net/archive
|