healeys
[Top] [All Lists]

Re: [Healeys] BJ 8 Clutch Question

To: "'E.A. Driver'" <edriver@sasktel.net>, <healeys@autox.team.net>
Subject: Re: [Healeys] BJ 8 Clutch Question
From: "PG" <britishcars@shaw.ca>
Date: Mon, 6 Apr 2009 09:30:48 -0700
Used the Finespanner extension yesterday.....great investment....well worth
the money.

Satisfied customer.

Paul

-----Original Message-----
From: healeys-bounces@autox.team.net [mailto:healeys-bounces@autox.team.net]
On Behalf Of E.A. Driver
Sent: Sunday, April 05, 2009 10:07 AM
To: healeys@autox.team.net
Subject: Re: [Healeys] BJ 8 Clutch Question

For those of you who are looking for various products produced by Doug 
Reid, aka Mr Finespanner
they are found in the technical section of 
www.vintage-sportscar-touring.ca as it an e-mail link
to Doug.  In addition there are a series of technical articles written 
by Doug that are worth a read.

Kind regards
Ed
Historian, AHCUSA
Saskatoon, Saskatchewan
'53 BN1 '65 BJ8  '89 Morgan 4/4


John Sims wrote:
> OK. Here's the deal. For about 35-40 bucks you can buy the clutch slave
> cylinder bleed extension which will, in the future save you a lot of
> aggravation as you will then be able to bleed from inside the engine
> compartment with no strain or pain. This extends the bleed line to above
the
> oil filter. Email Doug Reid at: mrfinespanner@earthlink.net. I would
suggest
> that you go ahead and get this before you start to bleed if you are
willing
> to wait a week or so. Then, use a speed bleeder at the tip of it and you
can
> bleed by yourself. No financial interest, yadda yadda yadda just a very
> happy customer of Doug's
>
> If you want to do it right now, you can get to the bleeder by pulling your
> tranny cover or by underneath the car but you need small fingers.
>
> John Sims, BN6
> Aberdeen, NJ
>  
> www.healey6.com
>
>
> -----Original Message-----
> From: healeys-bounces@autox.team.net
[mailto:healeys-bounces@autox.team.net]
> On Behalf Of STOCKLAND@aol.com
> Sent: Sunday, April 05, 2009 12:11 PM
> To: healeys@autox.team.net
> Subject: [Healeys] BJ 8 Clutch Question
>
> Just replaced the flexible hose to the clutch slave cylinder and now I
need
>
> to bleed the system.  However, I cannot get to the bleed screw.  Is  there

> some technique I am missing?  Thanks for your suggestions.
>  
> Jon
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys

You are subscribed as britishcars@shaw.ca

http://www.team.net/archive
_______________________________________________
Support Team.Net http://www.team.net/donate.html

Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys


http://www.team.net/archive

<Prev in Thread] Current Thread [Next in Thread>