Unbolt the cylinder and let it hang by the hose. Let fluid dribble out
for a minute or so. Or use a distributor wrench to loosen the bleeder
and let the fluid dribble out for a while.
Ken Freese
65 BJ8
-----Original Message-----
From: healeys-bounces@autox.team.net
[mailto:healeys-bounces@autox.team.net] On Behalf Of STOCKLAND@aol.com
Sent: Sunday, April 05, 2009 9:11 AM
To: healeys@autox.team.net
Subject: [Healeys] BJ 8 Clutch Question
Just replaced the flexible hose to the clutch slave cylinder and now I
need to bleed the system. However, I cannot get to the bleed screw. Is
there some technique I am missing? Thanks for your suggestions.
Jon
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
http://www.team.net/archive
|