The Concours Guide was misquoted. It states under the BN4 section (first of
the 4 seaters that had this cardboard cover) that the screws were Phillips.
Of course the BJ8 series had similar screws but they were Posidrives. Yes,
the judges would know the difference.
Rich Chrysler
----- Original Message -----
From: "Mark Schneider" <mandmschneider@comcast.net>
To: <DENewman2@aol.com>
Cc: <healeys@autox.team.net>
Sent: Thursday, April 02, 2009 2:38 PM
Subject: Re: [Healeys] Fasteners Securing Cardboard Around Fuel Filler Pipe,
BJ8
> Sirs,
>
> Like Don Newman, I know the history of My car. I bought it from the
> original owner forty years ago so I know the fasteners in the boot are
> the original hardware. They are Pozidrive. I guess that means the
> Concours Committee has relaxed the requirement and will accept a look-
> alike Phillips head???
>
> Marks3
>
>
> On Apr 2, 2009, at 11:33 AM, DENewman2@aol.com wrote:
>
>> I also checked my car this morning. Pozidrive 1/2 ".
>> I am the original owner so I am sure that is how the car came from
>> the factory.
>>
>> Don
>>
>> In a message dated 4/2/2009 11:08:40 A.M. Pacific Daylight Time,
>> mandmschneider@comcast.net
>> writes:
>> Sirs,
>>
>> I just went to the garage to check. The fasteners in my boot are
>> Pozidrive button head screws. The heads are approximately 5 mm in
>> diameter. I didn't extract any to measure the length but I recall
>> they are not very long. They are definitely not Philips head screws
>> and they are the original Pozidrive screws that were put in the car at
>> the time of manufacture. Whenever possible I have reused the same
>> fasteners in the same application as original construction. If you
>> need more detail, eg, size and thread type, please let me know.
>>
>> Marks3
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
http://www.team.net/archive
|