Randy,
1. The disc should be Girling, not Lockheed unless it's some sort of
replacement. How far off is it dimensionally?
2. Free play at the diff should be minimal. Is the clunking when you apply
power, then let off? Are you sure the drive shaft isn't contacting something
else in the tunnel? Check for tightness of rear shocks to frame and to link
to axle.
3. The L shaped carpet pieces will be fitted into the upper back corners
between wheel arch and rear panel that seperates the interior from the boot
area. can you send me pictures of tose carpet pieces?
Rich Chrysler
----- Original Message -----
From: "Randy Dickson" <rdickson@midwestarchaeology.com>
To: <healeys@autox.team.net>
Sent: Wednesday, March 18, 2009 11:32 PM
Subject: [Healeys] First Drive in 26 Years and three problems!
> Fellow Healeyoids,
>
> Well, I finally got my 63 BJ7 out on to the road yesterday, after a total
> nut and bolt frame off restoration and a 26 year hiatus. I drove around
> the
> block a few times and noticed a couple of problems. These problems are
> aside from the usual oil leaks which I'm going to work on later.
>
>
>
> 1). The brakes were pulsing when I applied them. I figured a warped disc
> or drum. All four were turned. I got home, jacked up the car. Removed
> one
> front brake disc, installed a new one I had and it bound against the stub
> axel or backplate. It would not turn. It is substantially thicker than
> the
> old original one and I wonder, it is a NOS Lockheed disc from a long time
> ago. Maybe I have to grind on my backplate or on the bolt heads on the
> stub
> axel. What is the likely problem?
>
>
>
> 2). Something kept clunking, or I would have driven further. It sounded
> like it was coming from the driveshaft. Inspection revealed the
> driveshaft
> was fine and new U-joints were installed, bolts tight. I think that the
> problem may be in the rear end center as it seems to have substantial
> movement when the driveshaft it rotated. Maybe it needs to be re-shimmed.
> This is about the only thing I did not touch on the car, as well as the
> shocks and springs. I will get to them eventually, but how much is the
> rear
> differential supposed to move when the driveshaft is rotated?.
>
>
>
> 3). Lastly, two pieces of carpet that I can't figure out where they go.
> They are boot shaped or letter L shaped. They go somewhere around the
> rear
> wheel arch but I don't know how they attach.
>
>
>
> Thanks! I will have more bugs to work out later.
>
>
>
> Randy
>
>
>
> Healey Archaeologist
>
> 63 BJ7
>
> 60 BT7
>
> 06 Mini Cooper S
>
> 66 Cobra replica
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
>
> Healeys@autox.team.net
> http://autox.team.net/mailman/listinfo/healeys
>
> You are subscribed as richchrysler@quickclic.net
>
> http://www.team.net/archive
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
http://www.team.net/archive
|