Hi Doug,
The two wires are attached to lights that illuminate the gauge and the high
beam indicator. Carefully remove (pull) the bottom light (high beam
indicator) out of the black plastic sleeve leaving the sleeve attached to the
speedo housing. Pull the entire light assembly out of the top area-it just
pops in and out of the hole with little compression fingers. Don't pull on
the wires though.
Take care,
George Haywood
'65 bj8
> From: ashbrook@mail.nih.gov
> Subject: [Healeys] Removing BJ8 speedometer
>
> I need to send the speedometer for my 67 BJ8 in for repair. I was able to
> remove it except for the 2 wires, which I assume are for the panel lights.
I
> am unable to figure out how to remove those wires. Can anyone tell me how
to
> do it? Thanks.
_________________________________________________________________
Hotmail. is up to 70% faster. Now good news travels really fast.
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
http://www.team.net/archive
|