Wes,
Straight behind (or rather in front of) the deepest part of the glove box
interior liner, there should be two small screws holes near the bottom of
the scuttle box section. A simple L bracket screws onto the scuttle box
section and extends back from this mounting point to a single screw with
flats and nut into the bottom end of the inerior liner.
Rich Chrysler
----- Original Message -----
From: "Weston Keyes" <westonkeyes@hotmail.com>
To: "Ahealey Ahealey" <healeys@autox.team.net>
Sent: Tuesday, January 20, 2009 11:55 AM
Subject: [Healeys] BJ8 location of support bracket for glove box?
> Hello Folks,
>
> Thanks for your continued support!
>
> I can't fine any holes in the body to attach the glove box support. Mine
> is a
> RH drive but I imagine it is symmetrical to a LH drive.
>
> Thanks
>
> Wes Keyes
> York, Maine
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
>
> Healeys@autox.team.net
> http://autox.team.net/mailman/listinfo/healeys
>
> You are subscribed as richchrysler@quickclic.net
>
> http://www.team.net/archive
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
http://www.team.net/archive
|