How deep should the holes be?
Are they all the way through?
If not, are they drilled from the top or the bottom?
Are you talking 4 holes only?
Every 4 inches on center across the seat?
4 inches apart across the seat?
In a message dated 11/10/2008 10:47:28 P.M. Eastern Standard Time,
pennell@cox.net writes:
Richard,
I did this many years ago and have very good results. I used a 1.5 to 2
inch hole saw (not sure of exact size) and drilled a 4 by 4 pattern. Not too
hard, not too soft - just right!
Keith Pennell
> Hi Group,
>
> I have new foam seats and find they are too stiff. Anyone have any
> recommendations as to where, how many and how deep the 1" holes should be
to
> make the seats softer.
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
You are subscribed as insidedim@aol.com
http://www.team.net/archive
**************AOL Search: Your one stop for directions, recipes and all other
Holiday needs. Search Now.
(http://pr.atwola.com/promoclk/100000075x1212792382x1200798498/aol?redir=http://searchblog.aol.com/2008/11/04/happy-holidays-from
-aol-search/?ncid=emlcntussear00000001)
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
http://www.team.net/archive
|