Hi Rich,
I have both these brackets missing on my 100's and have been looking at making
them, do you have any dimensions to work to??? I also have the inner apron
parts missing front of the radiator and the vertical piece, is there anywhere
to acquire the dimensions for these? again I am looking at making them.
Regards
Craig
Message: 12Date: Sun, 26 Oct 2008 11:50:16 -0400From: "Rich C"
<richchrysler@quickclic.net>Subject: Re: [Healeys] 100-4 originality
questionTo: "Paul Barnes" <fiat500f@aol.com>Cc: Healeys
<healeys@autox.team.net>Message-ID:
<91CEA9ECFA404A2B83DC5DD18A06A29A@ophrdc.org>Content-Type: text/plain;
charset="us-ascii" Paul, The forward frame members each have an L shaped plate
welded to the top of the frame surface that extends forward, then turns up 90
degrees vertical. Then another loose 90 degree bracket bolts to the vertical
plane of the welded piece and faces forward. These have a right and left side
taper (thinner to the outside of the car) and holes will align with the bottom
apron flange of the aluminum shroud. See picture att'd. Rich Chrysler
_________________________________________________________________
X Factor: latest video, features and more. Click here!
http://clk.atdmt.com/GBL/go/115454063/direct/01/
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
http://www.team.net/archive
|