Paul,
The forward frame members each have an L shaped plate welded to the top of
the frame surface that extends forward, then turns up 90 degrees vertical.
Then another loose 90 degree bracket bolts to the vertical plane of the
welded piece and faces forward. These have a right and left side taper
(thinner to the outside of the car) and holes will align with the bottom
apron flange of the aluminum shroud. See picture att'd.
Rich Chrysler
----- Original Message -----
From: "Paul Barnes" <fiat500f@aol.com>
To: <Healeys@autox.team.net>
Sent: Sunday, October 26, 2008 2:38 AM
Subject: [Healeys] 100-4 originality question
> Hi again,
>
> My friend and I continue working on his '54 BN1 and we have a question
> about
> the front shroud, lower front mountings. Below the grille, at the bottom
> of
> the front shroud, there are two sets of brackets which are suppose to
> fasten
> the lower shroud edge to the front of the chassis frame. The are two
> brackets
> on each side, and, they are all different. My friends car is missing all
> the
> brackets, and the lower lip of the shroud right were the brackets attach
> is
> torn off. We got the brackets from Kilmartin, but we don't see how they
> go
> together. And are the brackets that touch the frame welded to the frame?
> There don't seem to be any screw/bolts holes or anything on the ends of
> the
> frame. Photos?
>
> Thanks,
> Paul B.
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
>
> Healeys@autox.team.net
> http://autox.team.net/mailman/listinfo/healeys
>
> You are subscribed as richchrysler@quickclic.net
>
> http://www.team.net/archive
[demime 1.01d removed an attachment of type image/jpeg which had a name of
DCP00836.JPG]
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
http://www.team.net/archive
|